Albert Porter Technics SP10 MK3 Project

Description

This is a project that's been on going since the days of my Lenco experiments. My Lenco project is posted as a virtual system here at Audiogon too.

My Technics SP10 MK2 in custom African Wenge plinth is posted in my main system and this Technics SP10 MK3 in Panzerholz and Ebony Plinth was completed November 20th, 2008.

More images to follow, including the Ebony custom platform it will rest on. The platform is 9 layer construction including a layer of Texas Instruments shield with active ground plane.

Components Toggle details

- Technics SP-10 mkIII
This is to document my Technics SP10 MK 3 project
- Technics SP-10 mkIII
Finish view with SME 312S and Air Tight PC-1, now replaced with Air Tight Supreme
- Technics SP-10 mkIII
Detail of copper clad platter assembly,
- Technics SP-10 mkIII
Chassis with platter removed. This uses a record cutting motor for drive system,
- Technics SP-10 mkIII
Detail of construction of Ebony plinth
- Technics SP-10 mkIII
Detail of Ebony plinth construction
- Technics SP-10 mkIII
Detail of rotor-motor. Underside of Technics MK3 platter.
- Technics SP-10 mkIII
Panzerholz construction core for project. Completed plinth with Ebony lumber exterior and hardware is approximately $3800.00
- Technics SP-10 mkIII
Panzerholz assembly with Technics SP10 MK2 for basic measurements. Core Panzerholz plinth with no finish is approximately $1800.00

Comments 178

Showing all comments by sebastienl.

View all comments

Albert,

Is there any advantage to use the SME 312S without the finger lift as seen on your set-up pictures?

Sébastien

sebastienl April 20, 2012 01:47

Hi everyone,

I'm wondering which Stillpoint's spikes should I use for my Technics SP-10 panzerholz plinth. I'm looking for something that will allow me to adjust the height a little bit.

Thanks,

Sébastien

sebastienl April 18, 2012 16:55

Audiogon

Forum

Bluebook

Merch