Description

This system was made in almost complete isolation and with no other comparables to judge it against, other than distant memories I have of over 20 years ago as to what high end sound is suppose to sound like. I don't have any high end audio stores where I live, nor any people around to go and listen to their systems, so my system represents what "I" think sounds good and not necessarily what "is" suppose to be good. In some ways this is good - I don't know what I'm missing, and in some ways it's bad, I don't know what I'm missing and don't have any direction to follow.

Also of interesting note, is that all of my system has been mail order, and I have been forced to choose from companies with return policies in case the rather expensive (to me) don't measure up to what I was looking for. This, as you might expect, has limited me somewhat. However, I have used Audiogon to great success in garnering knowlege and understanding to pic many of the pieces I currently have. But like most audiphiles I have strayed down a wrong path or two to get here.

As for the sound? Hmmmm. Not sure how to describe it since there is nothing I'm comparing it to, but key thoughts might be "open", "clear" and "presence". The presentation hovers around the speakers and leans to a foward presentaion. Singers are in the room - whick I like. Imaging is great and very three dimensional. Bass is very good with just the Thiels, but the REL sub really fills in the bass below 30 Hz and blends seamlessly to my ears. I wish I could speak with some authority about tone, but all I can say is that it is neutral to my ears, but I really don't know since I've never heard another truly great system as a basis of comparison.

In the end, I can tell you that the system moves me and has let me enjoy music in ways I didn't think was possible. So in that way I judge it as a success.
Read more...

Room Details

Dimensions: 16’ × 21’  Large
Ceiling: 10’


Components Toggle details

    • OPPO BDP-93
    Used as transport
    • NAD M51 DAC/Preamp
    DAC/Preamp
    • Cardas Clear Light XLR
    1 meter Pair
    • Parasound Halo A21
    250w - 8 Ohms 400w - 4 Ohms
    • Purist Audio Design Venustas
    3.5 meter
    • Thiel Audio CS2.4
    Floor Standing, full range
    • REL Acoustics R-328
    Subwoofer
    • Pangea Audio AC14SE Signature
    Power cable for subwoofer
    • Furman Elite-15 PFi
    Power Conditioner
    • Pangea Audio AC-9SE Signature
    Power Cord for Power Conditioner
    • Balanced Audio Vk-3ix
    Tube Preamp
    • Cardas Clear Light Interconnect
    DAC to Preamp
    • VPI Industries VPI Prime TT
    With JMW 3D tonearm
    • VPI Industries 300 rpm motor
    300 rpm motor
    • Symposium Rollerblock Jr
    Vibration isolation feet
    • Parasound JC3+
    Phono preamp
    • Phoenix Engineering Eagle PSU
    Speed control for turntable motor
    • Phoenix Engineering Roadrunner
    Tachometer that works in concert with Eagle speed controler

Comments 30

Showing all comments by cmalak.

View all comments

Gary...there are a number of cartridge alignment accessories that can help you dial in your cartridge more accurately. Here are a few for you to consider and read up on:

1) Feickert Universal Protractor ($250): http://www.musicdirect.com/p-7032-feickert-next-generation-universal-protractor.aspx
2) Fosgate - Fozgometer Azimuth Range Meter ($299): http://www.musicdirect.com/p-1278-fosgate-fozgometer-azimuth-range-meter.aspx
3) I'd also make sure you have a decent stylus force gauge to make sure your VTF is set accurately. Something like this: http://www.needledoctor.com/AcousTech-Stylus-Force-Gauge?sc=2&category=423

I am by no means a vinyl expert, so if you are in the same boat, it may make sense to also just have a local turntable setup expert (either at a local dealer or audio club) come check out your set up. Otherwise, you can try using the tools above and get Michael Fremer's DVDs for turntable set up and see if you can dial in your cartridge alignment just right. just figure on a lot of trial and error until you get there.

Good luck.

cmalak

Last lemming...let me first congratulate you on putting together a wonderful system. I understand that you feel like you don't have other benchmarks by which to jusdge your own system but let me say that the following quote from your system description is the best way by which to jusdge your own system:

In the end, I can tell you that the system moves me and has let me enjoy music in ways I didn't think was possible.

And yes by that metric alone, you have achieved success and what this hobby is all about. It's not about who has the largest or most expensive system but rather about putting together whatever combination of gear that fits your budget that allows you to experience an emotional connection with your music in a way that makes you want to delve more into your existing music library and to want to explore new music.

One suggestion as it relates to the pops and clicks with your vinyl is for you to invest in a record cleaning machine (you can spend $500 and get a VPI or Okki Nokki motorized entry level RCM or you can go with a manual but very effective Spin Cleaner for $79). I think you will find that this will reduce substantially (but not altogether eliminate) the pops and clicks you are currently experiencing.

Check out Agon for threads on record cleaning of which there are a gazillion :-)

Congrats once again and enjoy!

cmalak