I purchased an early Sirius from Andy Payor thinking that I had purchased the ultimate turntable, only to spend the next five years updating. The updates have included the air isolation base, a series of different motors and tonearms, an outboard power supply for the motor, a 50# platter, new arm wiring and a variety of different belts culminating in a custom aramid fiber belt. As currently constituted, I think that it combines the high definition of the Sirius II without its tendency toward coldness.

Similar in many ways to the CTC Blowtorch but harmonically richer and more complex with greater dynamics and significantly better image density. Phenomenal bass, ultra quiet, very extended upper octaves.

Ebony with black faceplate. Particularly nice top end coupled with an ability under the best circumstances to recreate a three dimensional soundstage. After owning a number of Magnum Dynalabs, this has been a real eye opener.

The Triolons are an imposing sight. Two woofer towers, each 14" by 28" by 7' tall, each weighing 650# plus a cross piece holding a plasma tweeter attached to the woofers and a sword bearing two horn loaded speakers, one horn 30.5" in diameter, the other 18.5" in diameter. The Triolons can be driven by a single amps of 18 watts or higher power but must be triwired and have an efficiency of 97 db. Each side weighs 850# total. The crossover points are 200, 700 and 5000 hz. The sound from 200 hz up to 40,000 hz emanates as a spherical wavefront. The Campanile Highs are similar but crossover to their woofers at 700 hz, use the plasma tweeter plus a single horn and are much lower in efficiency (92 db). The Triolons are typically a 6 ohm speaker but have an impedance at 30 hz of 28 ohms. The same is true of the Campaniles. Neither is a particularly easy load for an amp to drive; however the greater efficiency of the Triolons does open up the possibility of driving them with the right low power amplifier. Unlike the ribbon tweeter of the Magnepans, the Acapella's tweeter does not over shadow the other drivers. Extremely dynamic.

The Jorma Prime, either in balanced or single ended configuration is superb, particularly between amp and preamp but also on other inputs. I still use the balanced 7N Mexcel on the X01 and the Valhalla on the TT but otherwise have switched to the Jorma Prime.

5 shelf version installed as well as the amp stands. Again a nice and very audible improvement. Amazing the things that you blame on the equipment until you solve the resonance problems. Basically a no brainer. More improvement than changing a major piece of equipment.

I have been mildly dissatisfied for a number of years with my JC-1 amps when used to drive the Acapella speakers but have yet to find something that combined the ability to drive the speakers and give me the other characteristcs that I desired although I have been much taken with some tubed amps (small, single ended or OTL within their power limits. Let's just say that the insertion of a combination of Bi-wire and single wire prime has cused me to re-think the amp question. The Primes are simply the most musical natural top to bottom cables that I have ever encountered.

Isolation base

transformer coupled, silver wired, balanced, SET mono pair, 23 watts output

minimal body mass, excellent sound; more liquidity in the highs than the Titan i

6 outlet

Power cord

AC power cord

Step up transformer for low output moving coil catridge

Tubed phono stage

record clamp

german engineered isolation feet

Esoteric's next to top of the line transport.

Esoteric's latest thinking on D/A converters.