Description

I enjoy listening mostly to Jazz, and Classical.

This is the setup I have in my audio/video room: I use Signal Cable power cords for CDP, PreAmp, Amp, and the speakers.
Read more...

Components Toggle details

    • Rotel RCD-1072
    Burr Brown 1732 D/A converter, HDCD decoding, coaxial digital output, 12V trigger input, removeable power cord, remote control
    • Conrad Johnson CT6
    Type: Tubed stereo preamplifier Tube Complement: four 6922 Frequency Response: 2Hz to 100 kHz Maximum Output: 15 Volts rms Gain: 26dB Output Impedance: 850 Ohms Distortion: 1.0V Output less than 0.25 THD Hum and Noise: 100dB below 2.5 Volts Phase: phase inverting Dimensions: 15.5 x 19 x 3.315 (DxWxH in inches) Total Weight: 19 lbs.
    • Conrad Johnson MV-60
    E34L -- output tubes (newer version of EL34) 6SN7GTA Philco -- driver tubes 12AX7A -- input tubes
    • Quad ESL-988
    Maximum Power Output:2N/m2 at 2m on axis Sensitivity : 86db Impedance: 8 ohms (nominal) Maximum continuous input voltage: 10V Freq Response ~ 37 Hz to 21 kHz Dimensions (HxWxD): 94 x 67 x 31.5 cm Weight: 45 lbs each
    • Cardas Golden Cross Interconnect
    Length: 1M Outside Diameter: .415 RCA Capacitance: 25.5 pf/ft Cable AWG: 16.5
    • Cardas Golden Reference Interconnect
    Length: 1M Outside Diameter: .415 RCA Capacitance: 12 pf/ft Cable AWG: 26 x 3
    • Cardas Cross Speaker Cable
    Borrow from a good friend Length: 8 Ft Outside Diameter: .585 Inductance: .11 uh/ft/loop Capacitance: 34 pf/ft Cable AWG: 10

Comments 1

Showing all comments by emailists.

View all comments

Great idea to post room diagram.

I used to own Quad 63's and loved them.

emailists