Description

Worked very hard on the setup. Use RTA (RAL) to tune. Used room treatments for all first order reflections including the ceiling. Use DSP for a little node correction. Flat to 32hz. Imaging excellent - would be better if the room was wider. Have never heard a system in the same price range that sounded better.
Read more...

Components Toggle details

    • Denon DCD-1520
    Use it as a transport
    • Audio Alchemy DITB
    None
    • Systemdek IIX
    Tweaked - Dynamat on plinth, mechanics, armboard and motor. Took the base off.
    • Systemdek OEM
    None
    • Shure 97MxE
    None
    • AMC CVT-3030a
    Tweeked by Retrodaze. Tube sockets, JJ tubes, larger supply caps and Auricaps in signal path.
    • Triangle Celius 202
    None
    • Dakiom R103
    On Tape In - after Behringer 2496
    • Behringer FBQ-2496
    DSP for room correction after walls etc treated
    • Sound Quest Isol-Pads
    Vibration absorbtion. Under all gear. Even installed them in my spekers at the end of a new cross brace neer the woofers
    • Homemade CAT-6
    Twisted
    • Homemade Echo Eliminators
    Same idea as Echo Busters - but years earlier. Use them to kill echo flutter and in all first order reflection points - including the ceiling. Excellent combination for mids-high absorbtion - use foam wrapped in terrycloth
    • Goldring G-1012 GX
    Use with my solid state amp
    • Magnepan MMG
    Use with sub and old Pioneer receiver in 2nd system
    • Monolithic Audio PS-1
    Phono Amp
    • Shure M97XE
    MM

Comments 12

Showing all comments by imispgh.

View all comments

Owner
hmmmm

I tried the toe in change and like them where they are. I think the picture exaggerates the angle. I can see all of the inside edges from the my seat. The speakers are not fired right at me. They are a little over 2 ft from the side wall. Unfortunetly the room is only a little over 12ft wide. I could pull them closer but them I lose width. The imaging and soundstage are good because I kill the first reflection points. If this room were 5ft wider it would be perfect (very few modes compared to standard rooms due to the shape)

imispgh

Owner
System edited: Improved Picture

imispgh

Owner
System edited: Neglected to take care of first order reflection on slanted side wall

imispgh

Owner
The Speakers are 8.5ft from me and have 10ft open space behind them. This works because of the front firing port. I have this thing for not having anything in between the speakers or behind them. Helps with visualizing the image. Equipment racks between the speakers cuase too much of a distraction. The system is very flat down to 35hz - with a little help from my RTA for placement and a little digital parametric DSP.

imispgh

Owner
Louisville KY

imispgh

Owner
System edited: A couple updates

imispgh

Owner
Monument Colorado

imispgh