My system is located in a dedicated "Bonus" room above the garage. The room measurements are: 16'W X 29'L X 8'H. The system is located along the short wall. A sofa is strategically located that can seat three comfortably. Two satellite chairs are available when add'l audiophile buddies come by. I have attempted to configure the system for the enjoyment of jazz. Using a 100A subpanel, I plan to install four 20A dedicated lines: 1 for each monoblock, 1 for the Transport & DAC and 1 for the Preamp. Any thoughts on the type of subpanel to use? My main load center is a Siemens. I'm also looking to upgrade my interconnect between the preamp and the amp. Looking for a neutral cable in the $500 -$1500 range. Any suggestions? Thx. Ken P.
A three stage non-inverting 6SN7 based preamp line stage
Sierra Audio (PBN) Denali
Class A/AB fully differential high power Mosfet amplifier. 600W/ch monoblocks
Osborn Loudspeakers Epitome MK V w/Opt. Bass Units
3-way floorstanding speaker with 93 dB efficiency
LessLoss XLR Digital Cable
1m XLR;From Transport to DAC
Omega Mikro AVII Planar Analog
1m RCA;From DAC to Preamp
Tritium Ultra High Velocity Gold
4 ft, RCA cable;Preamp to Amp
Omega Mikro Planar Speaker III Silver (active)
Each conductor is a bare thin .001 inch, half-inch wide copper ribbon. The conductors are micro-silver plated on one side only. 2 pairs in use. 1 on main speakers with 6
LessLoss AC Filtering Power Cable
2m;with Oyaide model 079 double polished double gold plated power plugs. 3 in use: Transport, DAC and Preamp
TG Audio HSR-I2
6ft; The high current verison of the HSR-I cable with 20amp (female)connector. Used to power the monoblocks.
TG Audio HSR Line Conditioner
Conditioner with upgraded HSR-I embedded power cable. 1 duplex port used on the transport and DAC.
Sistrum Multi-Shelf Platform SP-6
Six shelf rack filled with Micro-Bearing Conductive Steel bearings.
Argent Audio Argent RoomLens
A reactive resonator that disperses and refracts sound. A trio of RoomLenses are used in the room.