Garrard 401 turntable and Loricraft PSU 401

I purchased this early Garrard 401 direct from a seller in England about a dozen years ago. At that time I sent it directly to Northwest Analogue for a complete refurbishment. I ordered the famous Jeremy bearing by Redbeard Audio and received it after a long wait of around eight months. I then shipped Table, bearing, and my Graham Phantom II supreme 12 inch tone arm to James Campbell in Pennsylvania. Jim cut out a 22w x 19d two inch thick slab of Pennsylvania slate to fit the Garrard. He attached four two inch square blocks of the same slate with Stillpoint footers. Jim then drilled the 1.5 inch diameter tonearm hole and the four base holes at 295.6 mm Pivot to Spindle and installed the arm. I drove to Royersford PA and picked it up. It has been my analogue source until I recently purchased a new table and moved the Graham arm to it.

in preparation for this sale I shipped the 401 back to Jim for a fresh overhaul. The invoice is attached in the pictures.
The whole package is available for pickup only at my home near Lake George or I can ship the 401 table and Loricraft controller without the plinth. The Loricraft allows the table to be run at native UK voltage of 50 hz 200-220 volts. It is absolutely essential to provide the torque this idler wheel was designed for. Included in the sale is:

Audio Silente idler wheel with extra rubber ring
Original Stillpoint footers
Original Garrard bearing
Original power cords for the Loricraft 
Optional custom Cullen Cables and Furutech connectors for the Loricraft 
New cork Platter mat from England

The reward for making the journey to pickup is the plinth. You can install the 12 inch tonearm of your choice or re-drill or cut out the slate for a mounting board.

the price is the same with or without the plinth